It is good on virtual machine but installing on a system via USB or DVD it gives error.
After 65% of installation, giving error that verify installation sources are accessible and again restarts the installation.
Error Code 0xC0000005
Reasons: This error can be due to some configuration requirements for you system. You need to double-check your computerās hardware configuration against the following Microsoft requirements. also this could be happen because of....
1. Faulty Ram.
2. HDD have bad sectors or
corrupted.
These are the hot fixes below, only do try them if yours system is under required requirements.
Hot fix:
Delete the primary partition and the system reserved partition. this should make the disk raw. 1s done create a new primary partition. windows will then take 100mb and create a system reserved as well as a primary partition. quick format and install the primary partition.
Why? because not all partitions for different O.S's are compatible. so its always best to start with fresh created 1s unless you need to do recovery.
Hot fix 2:
what you must do is completely format all Volumes and merged them as one. Then changed them to basic. And then again create partitions into 2 volumes (or any above you want) one with (any specific size) for Windows installation and others (any specific size) partitions for personal use. i'm sure no error will shows up and windows will install successfully!
Good luck! hope you will fix it through these solutions.